论文部分内容阅读
图39 镶入饰缘把饰缘条镶入饰缘槽之前,需要检查线条的宽度与槽是否吻合,如果线条太宽,可以用刮刀或砂纸把线条磨窄一些。琴角部位的饰缘条需要用烙铁烤弯,否则容易折断。在琴角的交汇处两根饰缘条的项端都要用锋利的刀子削成坡形以便衔接。在两条饰缘条交接的位置需要做坡形的搭接。在一切准备妥当后,取出饰缘条在槽里灌上热胶液,然后把饰缘条放入,用小锤轻击,直到饰缘条到达槽府,再用热的湿布把挤出的胶液擦去。
Figure 39 Inserting the edge Before inserting the edge into the edge groove, you need to check whether the width of the line is consistent with the groove. If the line is too wide, use a scraper or sandpaper to narrow the line. Gusset parts of the edge of the need to use baking iron bending, or easy to break. In the intersection of the piano corner of the two ends of the trim should be sharpened with a sharp knife slope to convergence. Need to do slope-shaped lap joint in the place where the two ornaments meet. After everything is in place, remove the rim strip and pour the hot glue into the slot. Put the rim strip in and trowel with a small hammer until the rim reaches the slot house and the hot squeeze Glue to wipe.