论文部分内容阅读
AC97 Audio AC97 Modem 这两个选项的默认选项都是Disabled,如果你使用了AMR卡,建议你将此选项设置为Enabled。 IDE HDD Block Mode 此选项的默认选项是Disabled。如果你的IDE硬盘支持块传输,请将此选项设置成为Enabled,这样可以提高IDE硬盘的速度。 Power ON Function KB Power ON Password Hot Key Power ON 上述三项的设置允许你用热键或输入口令来打开系统。KB Power ON Password用来设置开机口令,按Enter键显示口令对话框。Hot KeyPower ON用来设置开机热键。 Onboard Serial Port 1 此选项的默认选项是3F8/IRQ4,用来指定内置的串口1的I/O口地址和中断请求号码IRQ。 Onboard IR 此选项的默认选项是Disabled,如果你已经安装了红外设备,必须将此选项设置为Enabled,否则红外设备不能正常使用。
AC97 Audio AC97 Modem The default options for both options are Disabled. If you are using an AMR card, we recommend that you set this option to Enabled. IDE HDD Block Mode The default option for this option is Disabled. If your IDE hard drive supports block transfers, set this option to Enabled to increase the speed of the IDE hard drive. Power ON Function KB Power ON Password Hot Key Power ON The above three settings allow you to turn on the system with a hot key or enter a password. KB Power ON Password Used to set the boot password, press Enter key to display the password dialog box. Hot KeyPower ON Used to set the boot hotkey. Onboard Serial Port 1 The default option for this option is 3F8 / IRQ4, which specifies the built-in serial I / O port address and interrupt request number, IRQ. Onboard IR The default option for this option is Disabled. If you have already installed an infrared device, you must set this option to Enabled, otherwise the infrared device will not work properly.