论文部分内容阅读
明显漏水部位处理方法: 一、根据基层厚度,把漏水处凿出一个胡萝卜形的尖眼。这时用速凝剂拌合水泥并立即用手搓成与孔眼大小相似的长条,快速塞进孔眼直至堵实塞严为止。随后在凿出的坑洼处用素水泥浆和1:2.5的水泥砂浆交替抹好,抹平,终凝后复盖并浇水养护。(注意:速凝剂有腐蚀作用,操作时应戴上胶皮手套。) 二、没有速凝剂时,可用干硬性砂浆捣
Obvious water leakage site treatment methods: First, according to the thickness of the base layer, the leaking point cut out a carrot-shaped sharp eyes. At this time, the cement was mixed with a quick-setting agent and immediately hand-rolled into a long strip of similar size to the hole, and quickly plugged into the hole until the plug was tight. Afterwards, the cement paste and 1:2.5 cement mortar were wiped alternately in the potholes, smoothed, finally covered and then watered to cure. (Note: The quick-setting agent has a corrosive effect and should be worn on the rubber gloves during operation.) 2. When no quick-setting agent is available, dry hard mortar can be used.