论文部分内容阅读
矫正扭曲的键子矫正扭曲的键子时,应根据键子形状和扭曲程度,分别施以不同方法。如果键子在管上是左右扭曲,一般可用平口钳矫正。钳口应垫有皮子或软木。矫正中应注意保持键盖的平正。如果键子起动角度偏小,可用镊子或改锥直接撬键盖或键子底部,有的键子则可用修整软木高度或锉键子底部的办法来增大角度。对于联动键子,则应注意调整后不要影响其它键子的高度。如果是键子起动角度过大,可据情采用以下方法: 1.通常的方法是用手指按住键子的两端(用一只手的拇指按住键盖,另一手的拇指按住键子另一端的棱角),同时用力下
Correction of distorted keys Correction of distorted keys, the keys should be based on the shape and degree of distortion, respectively, to impose different methods. If the keys in the tube is distorted around, generally available flat nose pliers correction. Jaws should be padded leather or cork. Care should be taken to maintain the key cover flat. If the key start angle is small, tweezers or screwdriver can be used to directly pry the key cover or key bottom, and some keys can be used to trim the cork height or the bottom of the file keys to increase the angle. For the linkage keys, you should pay attention to adjust the height of the other keys do not affect. If it is the key start angle is too large, according to the situation, the following methods are used: 1. The usual method is to hold down the keys with both ends of the finger (with one hand thumb and hold the key cover, the other hand thumbs down The other end of the corner), while under force