【摘 要】
：
Cross-section deformation is one of important factors affecting the quality of tube formation, and the tube’s capability of transporting liquid and gas will be
【机 构】
：
School of Mechanical Engineering,Beijing Institute of Technology,Beijing 100081,China
【基金项目】
：
Eleven Five Years Plan Basic Research Item of National Defense of China
论文部分内容阅读
Cross-section deformation is one of important factors affecting the quality of tube formation, and the tube’s capability of transporting liquid and gas will be reduced because of the cross-section ellipse deformation due to the effect of shear load in plastic bending process. When the tube is bent, the extrados-wall bears the tension stress and the intrados-wall bears the compression stress, synchronously the cross-section is affected by the circumferential stress. According to the above, the distribution function and curve of tangential stress can be obtained according to force balance differential equations on circumferential direction and Trasca rule. Subsequently the real state and virtual state moment equations were established, a new method was presented adopting the virtual principle of deformation system to calculate the x-axis and y-axis displacement of arbitrary point on cross-section. So the major and minor axes of deformed cross-section can be calculated according to the displacements of each point, and the variety value of major and minor axes will be obtained further. Finally the theoretical calculating result is compared with NC tube rotary-bending experiment results to verify the rationality of theoretical analysis, and the cross-section deformation rule of thin-walled tube can be received.
其他文献
In mod manufacturing patt, there are many uncertain factors in the mod manufacturing process, such as changes of product attribute, changes of manufacturing res
Many simple nonlinear main journal bearing models have been studied theoretically, but the connection to existing engineering system has not been equally invest
In the pedestrian headform impact test mandated by the European pedestrian safety requirements, the contact friction between the headform and the engine hood af
The densities of CO_2 inclusions in minerals are commonly used to determine the crystallizing conditions of the host minerals. However, conventional microthermo
This work is aim at studying the dependence of fission yields on incident neutron energy,so as to produce evaluated yield sets of the energy dependence.Experime
The problem of leak location is actually a time delay estimation (TDE) problem. Since most exist-ing TDE methods may encounter the problem of high computational
An accurate circuit of PWM/PFM mode converting and a circuit of auto-adaptively adjusting dimension of power transistor are described. The duty cycle of the sig
The settlement substrates of nona-porous abalones (Haliotis diversicolor supertexta) are covered with biofilms in which several types of microorganisms coexist
In this paper, the hydrodynamically generated noise by the flow over an open cavity is studied. First, aeroacoustic theories and computational aeroacoustic(CAA)
Travel time Lamb wave tomography has been shown to be an effective nondestructive evaluation (NDE)technique for plate-like structures. The methods used previous