前言本文阐述光纤连接器插针端面的研磨抛光问题。众所周知,一般光学另件的加工大致可分以下四道工序: 1)粗加工,即切割毛坯。 2)研磨,通常称磨砂。 3)抛光。 4)倒角及定中心。如图1所示,光纤连接器插针是一个予先用环氧树脂将光纤定中心地胶粘在不锈钢管内 Preface This article describes the optical fiber connector pin end grinding and polishing problems. As we all know, the general processing of optical parts can be roughly divided into the following four processes: 1) roughing, that is, cutting rough. 2) grinding, usually called scrub. 3) polishing. 4) chamfering and centering. As shown in Figure 1, the optical fiber connector pin is a pre-epoxy resin to center the optical fiber glued in a stainless steel tube