用图所示的方法可制造冲裁模或弯曲模用的叠片式卸料板,它不但成本低廉,而且工作可靠。按顺序,在完成凹模和冲头的淬火和磨光后,将和凹模模面尺寸相同的厚1～1.3mm的钢板细心地放在模具上定位、冲孔,冲完所有孔以后,将所有的钢板叠在一起钻孔,然后铆在一起就形成了叠片式卸料板,将它安装在坯料导板上即可工作。假如需要增加冲头和孔之间的间隙,可相应扩大孔径。 The method shown in the drawing can be used to make laminated stripper plates for punching dies or bending dies, which is not only inexpensive but also reliable in operation. In order, after completing the quenching and polishing of the die and the punch, the steel plate having the same thickness as that of the die surface of 1 to 1.3 mm is carefully positioned on the die to punching and punching all the holes, Bring all the steel sheets together and drill them together, then riveted together to form a laminated stripper plate that can be mounted on the strip guide. If you need to increase the punch and the gap between the holes, you can expand the aperture.