我厂有六台250公斤以上的空气锤已使用多年,砧座燕尾槽工作面变形,上下砧工作面不平,致使锻件厚薄不匀,质量下降,操作时的不安全因素也随之增加。采用通常的修理方法,周期长,费用大。为此,我们决定制造一台专用铣床来修复砧座的工作面。砧座专用铣结构简单,使用性能可靠,造价约3000元。经多年使用,效益十分显著: 1.修理周期短。常规修理砧座一般要一 Our factory has six sets of air hammer over 250kg have been used for many years, the anvil dovetail face deformation, uneven anvil face up and down, resulting in uneven forging thickness, quality decline, the operation of the unsafe factors also will increase. The usual method of repair, long cycle, costly. To this end, we decided to create a dedicated milling machine to repair the anvil face. Anvil-specific milling structure is simple, reliable performance, cost about 3,000 yuan. After years of use, the benefits are obvious: 1. The repair cycle is short. Routine maintenance anvil generally one