A novel construction method of QC-LDPC codes based on CRT for optical communications

来源 :OptoelectronicsLetters | 被引量 : 0次 | 上传用户:keliok
下载到本地 , 更方便阅读
声明 : 本文档内容版权归属内容提供方 , 如果您对本文有版权争议 , 可与客服联系进行内容授权或下架
论文部分内容阅读
A novel construction method of quasi-cyclic low-density parity-check (QC-LDPC) codes is proposed based on Chinese remainder theory (CRT). The method can not only increase the code length without reducing the girth, but also greatly enhance the code rate, so it is easy to construct a high-rate code. The simulation results show that at the bit error rate (BER) of 10-7, the net coding gain (NCG) of the regular QC-LDPC(4 851, 4 546) code is respectively 2.06 dB, 1.36 dB, 0.53 dB and 0.31 dB more than those of the classic RS(255, 239) code in ITU-T G.975, the LDPC(32 640, 30 592) code in ITU-T G.975.1, the QC-LDPC(3 664, 3 436) code constructed by the improved combining construction method based on CRT and the irregular QC-LDPC(3 843, 3 603) code constructed by the construction method based on the Galois field (GF(q)) multiplicative group. Furthermore, all these five codes have the same code rate of 0.937. Therefore, the regular QC-LDPC(4 851, 4 546) code constructed by the proposed construction method has excellent error-correction performance, and can be more suitable for optical transmission systems.
其他文献
本文采用了一种特别的多模电-声子耦合模型,利用室温光谱数据估算可调谐激光晶体的黄昆-里斯(Huang-Rhys)S因子,并与单模耦合模型的结果作了比较.最后,还讨论了S因子与晶场强度及基质晶体价键特性之间的关系.
Based on the transverse second-harmonic generation(TSHG) effect, we demonstrate a method for in-situ modal inspection of nonlinear micro/nanowaveguides. Pumping lights are equally split and coupled in
We report the adaptive compensation experiment of polarization mode dispersion (PMD) for 10-Gb/s non return-to-zero (NRZ) and return-to-zero (RZ) optical communication systems using a two-stage PMD compensator and the monitoring technique based on degree
期刊
期刊
根据今年六月慕尼黑国际量子电子学会议上国标商用机器公司研究中心的杰克逊(D. Jackson)与该公司的威纳(J. Wynne)合作提出的报告,去年西德海德堡大学的托谢克(P. Toscheli)和他同事们报道的“双光子”激光,事实上可能是一例参量混频。
期刊
为了克服传统数字全息三维成像技术的扫描速度慢等诸多缺点,设计一种仅需单波长且可以一维扫描的透射式K空间变换数字全息三维成像技术。首先采用片状光束对样品进行照明并记录透射光的离轴全息图;然后利用传统的数字全息重建技术得到透射光的复振幅分布后去除其低频分量;最后在频谱空间进行坐标变换并对变换后的空间频谱进行傅里叶逆变换,便可得到被照明切片平面上的样品结构信息。在对工作原理和主要参数进行系统理论分析的基础上,利用数值模拟和光学实验对此技术的可行性进行实际验证。由于该技术能够使用透射光进行三维层析成像,因此很容易
用具有高灵敏的共线光热偏转技术研究SiO2、ZrO2、MgF2、ZnS等单层光学薄膜的吸收特性,测得它们的吸收率.实验结果与激光量热法及横向光热偏转技术符合良好,表明共线光热偏转技术是测量光学薄膜弱吸收的较理想方法.
V-doped MgAl6O10 is grown by the conventional Czochralski method. The crystal structure and the cell parameters are analyzed through X-ray diffraction experiments. The absorption and emission spectra are investigated. Under pumping at 324 nm, the emission
本文比较了应用电光调制器进行的激光器内外振幅调制。如果激光器增益与调制器损耗之比很高,内相位调制就能给出较高的信号输出功率和较好的信噪比,效率也较高。
期刊