模具安装的要点之一是将压力机闭合高度调整为一合适值,这样方可冲压出合格的零件。压力机闭合高度大小,可通过连杆来调节,若连杆伸长到最大值时仍然嫌闭合高度太大,可在冲模下面增加垫板来解决。 冲压实践中还会碰到与上述相反的一种问题,即压力机吨位足够,而闭合高度不够。 One of the key points of the mold installation is to adjust the height of the press to a suitable value so that the qualified parts can be stamped out. Presses closed height size can be adjusted through the connecting rod, if the connecting rod is still too closed to extend the maximum height is too large, you can increase under the die pad to solve. Stamping practice will encounter the opposite of the above problems, namely, press enough tonnage, and closed height is not enough.