论文部分内容阅读
某钢厂3号特厚板坯连铸机后部辊道安装了摆锤式去毛刺机,用于去除火焰切割产生的毛刺,但经过半年多的使用,发现该设备存在一些不足:毛刺机旋转主轴与V型导向滑轨的间隙测量及调整极为繁琐,毛刺机旋转主轴高度限位机构存在不足。为了消除毛刺机存在的问题,通过对现场实际情况进行研究及理论分析,对摆锤式去毛刺机进行一系列的结构优化改进,通过优化改进彻底解决了摆锤式去毛刺机存在的设计不足,提高了去毛刺的效率,并且降低了该设备的维护费用。
A steel mill No. 3 extra-thick slab caster rear roller mounted pendulum deburring machine, used to remove burrs caused by flame cutting, but after more than six months of use, found that the device there are some deficiencies: Burr The measurement and adjustment of the clearance between the rotating spindle and the V-shaped guide slide are very complicated. There is a deficiency in the height limit mechanism of the rotating spindle of the burring machine. In order to eliminate the problems existing in the burr machine, a series of structural optimization and improvement of the pendulum deburring machine was carried out through the research and theoretical analysis of the actual situation in the field, and the design problem of the pendulum deburring machine was completely solved through the optimization and improvement , Increases deburring efficiency, and reduces maintenance costs for the device.