论文部分内容阅读
问11:怎样安装LCD硬件?(续上期)答:3.安装方法在安装硬件前,应确保计算机和显示器的电源均已关闭,然后按照以下五个步骤进行。(1)将显示器上的基板向后完全拉出。安装显示屏时,不要将手指插入基板与显示器的接合处。(2)如图5所示,将显示器放置在基板中,直至锁定位置,安装时会发出“咔嗒”声,说明已到锁定位置。(3)如图6所示,连接电源线和信号电缆。图6(a)所示将电源线连至显示器,图6(b)所示将信号电缆连接至显示器。
Q11: How to install the LCD hardware? (Continued) Answer: 3. Installation Before installing the hardware, make sure that the computer and monitor are both powered down and then follow the five steps below. (1) Pull the monitor back out completely. When installing the display, do not insert your finger into the junction of the base and the monitor. (2) As shown in Figure 5, place the monitor in the base until it locks into place, and a “click” sound will be heard during installation, indicating that it is in the locked position. (3) Connect the power and signal cables as shown in Figure 6. Connect the power cord to the monitor as shown in Figure 6 (a), and connect the signal cable to the monitor as shown in Figure 6 (b).