【摘 要】
：
Volumetric solar evaporations by using light-absorbing nanoparticles suspended in liquids (nanofluids) as solar absorbers have been widely regarded as one of the promising solutions for clean water production because of its high efficiency and low capital
【机 构】
：
Hubei Key Laboratory of Mineral Resources Processing and Environment,Wuhan University of Technology,
论文部分内容阅读
Volumetric solar evaporations by using light-absorbing nanoparticles suspended in liquids (nanofluids) as solar absorbers have been widely regarded as one of the promising solutions for clean water production because of its high efficiency and low capital cost compared to traditional solar distillation systems. Nevertheless, previous solar evaporation systems usually required highly concentrated solar irradiation and high capital cost, limiting the practical application on a large scale. Herein, for the first time in this work, polydopamine (PDA)-capped nano Fe3O4 (Fe3O4@PDA) nanofluids were used as solar absorbers in a volumetric system for solar evaporation. The introduction of organic PDA to nano Fe3O4 highly contributed to the high light-absorbing capacity of over 85％in wide ranges of 200–2400 nm because of the existence of numerous carbon bonds and pi (π) bonds in PDA. As a result, high evaporation efficiency of 69.93％under low irradiation of 1.0 kW m-2 was achieved. Compared to other nanofluids, Fe3O4@PDA nanofluids also provided an advantage in high unit evaporation rates. Moreover, Fe3O4@PDA nanofluids showed excellent reusability and recyclability owing to the preassembled nano Fe3O4, which significantly reduced the material consumptions. These results demonstrated that the Fe3O4@PDA nanofluids held great promising application in highly efficient solar evapo-ration.
其他文献
SrLi2Ti6O14 (SLTO) coated with different amount of ZrO2 was successfully prepared. The as-obtained composites are stacked by a series of particles with a pure phase structure and a good crystallinity. Furthermore, ZrO2 coating not only enhances the struct
Judiciously engineering the electrocatalysts is attractive and challenging to exploit materials with high electrocatalytic performance for hydrogen evolution reaction. Herein, we successfully perform the interface engineering by alternately depositing Co–
In this study, a series of CuMgAl layered double oxides (CuMgAl-LDOs) were obtained via calcination of CuMgAl layered double hy-droxides (CuMgAl-LDHs) synthesised via a co-precipitation method. The results show that CuMgAl-LDO can be prepared using an opt
Cr(VI)-based compounds pollution have attracted global concern due to serious harm to humans and environment. Hence, it is crucial to exploit an effective technique to eliminate Cr(VI) in water. Herein, we in-situ grown BiOI on graphitic carbon nitride to
In recent years, an increasing amount of interest has been dedicated to the synthesis and application of ZIF-67-based materials due to their exceptionally high surface area, tunable porosity, and excellent thermal and chemical stabilities. This review sum
Heteroatom-doped meso/micro-porous carbon materials are conventionally produced by harsh carbonization under an inert atmosphere involving specific precursors, hard/soft templates, and heteroatom-containing agents. Herein, we report a facile synthesis of
Asymmetric behaviors of capacitance and charging dynamics in the cathode and anode are general for nanoporous supercapacitors. Un-derstanding this behavior is essential for the optimal design of supercapacitors. Herein, we perform constant-potential molec
When I read the paper“Electrolytes enriched by potassium perfluorinated sulfonates for lithium metal batteries”from Prof. Jianmin Ma\'s group, which was published in Science Bulletin (doi.org/10.1016/j.scib.2020.09.018), I felt excited as presented a mu
Although TiO2 nanotubes is a promising electrode as supercapacitors due to its high energy density, easy synthesis and chemical stability, there are draw backs such as low conductivity and capacitance. Many studies concentrated on improving its electroche
The present work, in which cellulose isolated from formic acid fractionation (FAC) is decorated with polyetherimide (PEI) to attain highly efficient cellulose-derived PdAgbimetallic catalyst (PdAg-PEI-FAC), has been investigated, and the catalyst properti