颌间悬吊固定法是将下颌骨断端复位后,用悬吊钩将梨孔及与下颌骨周围结扎钢丝连接固定的一种方法(见图1)。用扁平钢丝按图2所示预先作好悬吊钩。钩的长臂约22～30毫米,短臂约8～10毫米。在长臂远端钻孔,并把短臂末端磨成长约3毫米的尖。应使长臂远端1/3的弯曲与齿槽突及牙齿弧度一致,能紧密接触。 Intermaxillary suspension fixation method is to reset the mandibular fracture, the hanging hook pears hole and the mandibular ligature wire around the connection and fixation method (see Figure 1). With flat wire as shown in Figure 2 pre-made suspension hook. Hook long arm about 22 to 30 mm, short arm about 8 to 10 mm. Drill the far end of the long arm and grind the ends of the short arm to a tip of about 3 mm. Should make the long arm 1/3 of the curvature of the alveolar process and tooth curvature consistent, can be in close contact.