用普通平板硫化机硫化如图1软连接橡胶件制品,硫化时所用压模由外模(凹模)和内模(模芯)来控制产品成型。但由于产品中间鼓凸,且两端要求将图示金属法兰盘一起硫化,硫化以后如何脱模是模具设计的关键。为此我们将模具设计成如图2所示的结构,外模5由两瓣组成,内模3由8块拼成,其中又分Ⅰ、Ⅱ两种形状,各为4块对称分布,闭 Vulcanized with a flat vulcanizing machine as shown in Figure 1 soft connection rubber parts products, curing the mold used by the outer mold (die) and the inner mold (mold core) to control the product molding. However, because the middle of the product bulging, and both ends of the required metal flange together cure, after curing how the mold release is the key to mold design. To this end, we will die design as shown in Figure 2, the structure, the outer mold 5 consists of two petals, the inner mold 3 made up of 8, which is divided into Ⅰ, Ⅱ two shapes, each 4 symmetrical distribution, closed