【摘 要】
：
To improve performance of PTFE-based damping material, composites with several fillers were prepared by compressing and sintering. The dynamic mechanical proper
论文部分内容阅读
To improve performance of PTFE-based damping material, composites with several fillers were prepared by compressing and sintering. The dynamic mechanical properties of the composites were investigated by means of viscoanalyser. Temperature-dependent loss factors, storage modulus and loss modulus were obtained.And SEM was employed to study the compatibility between PTFE and fillers. The results show that, when blending PPS and PEEK at proper content, the loss factor curve appears double peaks, which can widen the high-damping temperature region of the composites. Blending graphite or alumina can increase the storage modulus obviously, but decrease the value of loss factor. And because graphite or alumina combines with matrix poorly, glide would happen at interface when bearing external load. The interface friction can dissipate vibration energy, which increases the loss modulus of the composites. Blending PPS, PEEK and graphite or alumina at right content, PTFE-based composites can meet demands as damping material in practical engineering.
其他文献
In many experiments, the performance of a subject may be affected by some previous treatments applied to it apart from the current treatment. This motivates the
In order to compare the dosimetric properties of two kinds of solid state detectors used for monitoring external exposures,experiments Were performed for the GD
This paper aims to present an adaptive control scheme for the synchronization of two classes of uncertain neural networks with different attractors. A new suffi
The invariant sets and the solutions of the 1+2-dimensional generalized thin film equation are discussed. It is shown that there exists a class of solutions to
Amphiphilic ODA/HY and ODA/ Hβ zeolites have been prepared via chemically coating octadecylamine (ODA) with alcohol as solvent. IR and titrimetric results indi
A high etch rate GaAs via-hole process was studied in an inductively coupled plasma system using Cl2/BCl3 gas system. The effects of process parameters on the G
An intensity-based non-rigid registration algorithm is discussed, which uses Gaussian smoothing to constrain the transformation to be smooth, and thus preserves
提出了一种在高海拔通过测量直达质子来确定质子和空气核（p—air）的非弹性作用截面的方法．并通过Monte Carlo模拟，研究了其可行性．假定将一台类似于KASCADE的强子量能器设置在西藏
The in-line response of a vertical flexibly mounted cylinder in regular and random waves is reported. Both theoretical analyses and experimental measurements ha
In order to describe the characteristics of piezoelectric bimorph, properties of lead zirconate titanate (LZT) film are studied by X-ray diffraction (XRD) and s