论文部分内容阅读
第一汽车厂从1980年开始CA141汽车的开发工作,在新发动机CA6102研制过程中,为了提高新机型水平,向日本帝国活塞环公司订制了一批活塞环。据此日本帝国公司向我厂提供了活塞环设计图纸与样品。我厂对这些样品进行了全面测量,试验与装机使用。本文介绍日本帝国公司活塞环（简称TP环）样品的试验分析结果。 一、样品分析 1、活塞环的结构参数: 压线一@离黑猫置备八个临窗被蛐环>的因被与样翩始娜多数钢一互所承。_ 回一月。、。。-“,
The first automobile factory started the development of CA141 car in 1980. During the development of new engine CA6102, a series of piston rings were ordered to Japan Imperial Piston Ring Company to improve the level of new models. Accordingly, Imperial Japan provided the piston ring design drawings and samples to our factory. I plant a full measurement of these samples, test and installed use. This article describes the imperial company Japan Piston Ring (referred to as TP ring) sample analysis of the results. First, the sample analysis 1, the structural parameters of the piston ring: a pressure line away from the black cat prepared by the eight windows were 蛐 ring> was because of the same with the beginning of most of Pina steel bearing each other. _ Back to January. . . - ",