论文部分内容阅读
脱模机是太钢生产的关键设备。太钢连年大幅度增产,使脱模机处于严重超负荷工作状态,由于连续作业时间长,环境温度又高,因此液压油箱的温度高达108℃,使高压胶管高温老化,产生爆破,溢出液压用油引起大火。1986年为此停车修理756小时,严重影响生产。 在不允许再安装1台脱模机的条件下,我们试用过液氮和冷冻机进行油箱降温,但都因为条件恶劣没有达到满意的效果。后来我们想到了用油马达可以代替减速机。油马达个头小,把两个油箱都挖去一块,就腾出了安装位置,再把油箱加高100mm,
Stripping machine is the key equipment TISCO production. TISCO substantial increase year after year, so that stripping machine in a serious overload state, due to continuous operation for a long time, the ambient temperature is high, so the temperature of the hydraulic tank up to 108 ℃, high pressure hose aging, resulting in blasting, overflow hydraulic Oil caused fire. In 1986 this parking repair 756 hours, seriously affecting the production. We did not allow to install a stripping machine under the conditions, we tried liquid nitrogen and freezers tank cooling, but because of poor conditions did not achieve satisfactory results. Later, we thought of the oil motor can replace the reducer. A small oil motor, the two tanks are dug to a piece, to free up the installation location, and then raised the tank 100mm,