论文部分内容阅读
本文论述了鞍山热能研究所研制的铸造成型焦的试验效果,经底焦燃烧和初步生产熔炼试验表明:底焦燃烧时,可达到较冶金焦更高的炉内温度,与镇江铸造焦接近或稍高。熔炼时,在合理的炉型和工艺参数的配合下,当层焦比为1:9～10时,两种成型焦均能获得出铁槽平均为1500℃的高温优质铁水,硅、锰烧损减少,熔炼指标接近或达到镇江铸造焦的水平。为我国开辟了不用或少用焦煤生产铸造焦的新途径。本文还对铸造成型焦的研制提出了看法。
This paper discusses the Anshan Institute of thermal energy research and development of the casting molding coke results, the bottom coke combustion and preliminary production of melting test showed that: bottom coke combustion, higher than the metallurgical coke can reach the furnace temperature, and Zhenjiang foundry coke close to or Slightly higher When smelting, with proper furnace type and process parameters, when the layer coke ratio is 1: 9-10, both high-temperature high-quality hot metal with an average iron ingot of 1500 ℃ can be obtained from both forming coke, Losses reduced, smelting indicators close to or reached the level of casting coke in Zhenjiang. For our country opened up a new way to produce coke without or with less coking coal production. This article also puts forward the opinion on the development of casting forming coke.