论文部分内容阅读
我段原有一台二号緩冲器盒底切割轉台,是立式的,經实际使用說明,它有不用装卡、切割效率高的优点,但又有以下一些重要的缺点:①切縫大,熔渣多,且不易清除,影响以后盒底的接焊。焊完后,盒內圓弧面不平,要打磨。②切割盒底两侧时,必須把盒从轉台上拿下來,在地上滾来滾去,很不方便。据此,段里师傅們要求改成臥式的,并能用作平焊轉台之用。他們提出了盒子装卡的具体方案,經設計制造并近20次改进后,现已投入生产,使用情况良好,深受生产使用者欢迎。現将使用方法及原理介紹如下:
I had a paragraph on the 2nd buffer box cutting turntable, is vertical, the actual use of instructions, it has no card, cutting the advantages of high efficiency, but there are some important shortcomings: ① large kerf, More slag, and not easy to remove, affecting the bottom of the box after the welding. After welding, the box surface uneven, to be polished. ② cutting both sides of the bottom of the box, the box must be removed from the turntable, rolling on the ground to go, very inconvenient. Accordingly, the section of the master who asked to change into horizontal, and can be used as flat welding turntable purposes. They put forward the specific program of boxing card. After designing and manufacturing and nearly 20 times improvement, they have been put into production and are in good condition and are welcomed by the production users. The use of methods and principles are introduced below: