【摘 要】
：
The reduction diffusion method was performed for the sludge scrap of Nd-Fe-B sintered magnets with adding Ca metal to recover the oxidized Nd-Fe-B phase. After
【机 构】
：
Collaborative Research Center for Advanced Science and Technology
论文部分内容阅读
The reduction diffusion method was performed for the sludge scrap of Nd-Fe-B sintered magnets with adding Ca metal to recover the oxidized Nd-Fe-B phase. After washing the resultant powders to remove Ca metal component, the powders obtained were recycled as an isotropic magnetic powder by the melt spinning method. The magnetic properties of powders as recycled were inferior, especially for the coercivity value, due to the deletion of rare earth metals during the washing process. The adjustment of metal composition, i.e., the addition of Nd metal, at the melt spinning process improved the magnetic properties to be Br=～0.75 T, Hcj=～0.93 mA·m-1, and(BH)max=～91 kJ·m-3. The magnetic properties of the bonded magnets prepared from the composition-adjusted powders were Br=～0.66 T, Hcj=～0.92 mA·m-1, and(BH)max=～70 kJ·m-3, which are approximately comparable to the commercially available MQPB boned one(Br=～0.73 T, Hcj=～0.79 mA·m-1, and(BH)max=～86 kJ·m-3).
其他文献
本文详细阐述基于问题的案例式与循环实践式相结合的荒漠化防治工程学的课程教学改革模式的思路、实施过程及保障措施,为同类型课程的教学模式改革提供参考.
A mathematical model to calculate the size and distribution of microporosities was studied and coupled with a stochastic microstructure evolution model. The mod
Mold-filling process of thin-walled castings under the condition of traveling magnetic field has been studied by physical simulation method using gallium melt a
AZ31 Mg alloy was prepared through equal channel angular pressing (ECAP) by Bc route in two different dies, in which the intersecting angles between channels ar
The bond strength of electrodeposited nickel from common electroplate liquid and rare-earth electroplate liquid was tested and contrasted. Electrodeposited nick
The microemulsion AEO-9/butanol/cyclohexane/nitrate aqueous solution (or ammonium salt aqueous solution) was studied, which was used as micro-reactor in prepari
The effect of the deferent rubber content substituted for fine aggregate on the mortar performancewas studied. The effects of the rubber coated with the coating
The nanocrystalline La1-xSrxCrO3 was prepared by sol-gel method using La( NO3 )3 · 6H2O, Sr( NO3 )2 and respectively. The phase transformation from dry-gel to
Electrodeposited Ni matrix/Al microparticles or nanoparticles dispersed composite coatings (termed as EMCCs or ENCCs) are developed from a Ni-based electrolyte
The formation process, microstructure and mechanical properties of transient liquid phase (TLP) bonded aluminium-based metal matrix composite (MMC) joint with c