【摘 要】
:
The highly thermal stability precipitates strengthen creep resistance for alloys,which require precipitates to resist coarsen at elevated temperature.In the Mg-
【机 构】
:
Key Laboratory for Anisotropy and Texture of Materials (Ministry of Education),School of Materials S
论文部分内容阅读
The highly thermal stability precipitates strengthen creep resistance for alloys,which require precipitates to resist coarsen at elevated temperature.In the Mg-RE-Zn (Ag) series alloys,the key strengthening phase-γ\'\'phase,remains its single-unit-cell height throughout aging process.The origin of such extremely thermal stability of γ\'\'phase is still unclear.By using the first-principles calculations,it is found that the formation ofγ\'\'phase introduces compressive strain to its surrounding α-Mg lattice and simultaneously alter charge distribution of α-Mg lattice near the α-Mg/γ\'\'hetero-interface.These two variations over α-Mg lattice lead to lower vacancy formation energies and migration energy barriers for solute atoms near the α-Mg/γ\'\'hetero-interface in comparison with that of bulk condition.Consequently,the variations facilitate rapid diffusion of solute atoms near the γ\'\'phase and promote nucleation rate of other γ\'\'plates around it.On the basis of ledge-thickening model,the origin of nucleation/growth of γ\'\'phase with single-unit-cell height was explained.Thermodynamically and kinetically,the solute atoms are not apt to migrate into the nearest basal plane adjacent to the γ\'\'phase.Moreover,the lower aging temperature(~200 ℃) and almost completely coherent α-Mg/γ\'\'hetero-interface lead to the ledges are extremely hard to nucleate on the hetero-interface.Therefore,γ\'\'plates maintain single-unit-cell height throughout aging process.
其他文献
The discovery of new materials is one of the driving forces to promote the development of modern society and technology innovation,the traditional materials res
The phase equilibria and thermodynamic properties of the U-Nb system were investigated through experiments and thermodynamic modeling.In the experiments,a serie
Marine biofouling is a major issue deteriorating the service performance and lifespan of marine infrastruc-tures.The development of a durable,long-term,and envi
This work aims at understanding the features of the Sn grains from which whiskers preferentially grow.The growth behavior of Sn whiskers on a 50 μm thick hyper
In recent years,the Ti2AlNb-based alloys are selected as potential alloys for elevated temperature appli-cations to replace conventional Ni-based superalloys ow
Public safety incidents caused by bacterial infections have attracted widespread attention towards antibacterial textiles (fibers,fabrics,etc.).Nevertheless,it
So far,only two orientation relationships(OR)between hexagonal close-packed(HCP)(αphase)and facecentered cubic(FCC)structures in zirconium and titanium alloys have been reported.Here a new type FCC phase(named γ phase)with OR:<11■0>α‖<
本文针对2×660 MW机组锅炉送风机在正常运行过程中出现由叶片断裂造成的设备运行参数异常,进行原因分析,并结合断裂原因总结本次送风机叶片断裂事故的教训,从而为后续或同类型风机设备的检修提供参考依据。
Laser powder bed fusion (L-PBF) was utilized to produce specimens in Ti-6Al-4V,which were subjected to a bi-lamellar heat treatment,which produces microstructur
In this work,the beneficial effect of Sn addition on the corrosion resistance mechanism of Cr-Mo low alloy steel was studied.Results demonstrated that Sn improves the corrosion resistance of the steel matrix mainly by influencing the microstructural trans