床头箱前后二油池原靠人工定时加油,如忽略加油,主轴和轴瓦间会产生干磨,如浇油过多,又因油池小,轴瓦之间有间隙而在主轴两端漏油(图1)。现我们在床头箱上面加一长970毫米的分油盘,利用主轴箱齿轮运转时飞溅起来的一部分油液,经油盘的积蓄,分送到前后两个油池,自动供油,保证主轴和轴瓦润滑。为了安装分油盘,床头箱盖内侧需加工,留出空档。同时在主轴前端和小齿轮轴(02134)处各增设半环形接 Before and after the headstock two tanks by artificial timing refueling, such as ignoring the fuel, the spindle and the bearing will produce dry grinding, such as excessive oil, but also because the oil pool is small, there is a gap between the bearings in the spindle at both ends of the oil spill figure 1). Now we add a 970 mm long oil pan on top of the bedside box and utilize some oil splashed up by the gear of the spindle box to accumulate the oil pan and distribute it to the two oil pools before and after, Spindle and bearing lubrication. In order to install the oil pan, the inside of the headstock cover needs processing, leaving the neutral gear. At the same time in front of the spindle and pinion shaft (02134) at the addition of a semi-circular connection