平面到圆锥交线位置尺寸的简易检测方法图１所示工件从Ａ面到圆锥面加的尺寸ｆｆｉ？为“Ｈ”，该尺寸要求非常高，检测困难。现介绍一种标准检具，此检具检测较为方便，可用于现场检测。标准检具如图２所示。检具的制作应符合国２的要求，检具的训等于零件的必。检测方法... Flat to the intersection of the intersection of cone and the intersection of position and the intersection of size and the intersection of simple detection method and the intersection of piece and the intersection of job and the intersection of surface and the intersection of A and the intersection of surface and the intersection of conic and the intersection of size and ffi? For “H”, the size requirement is very high and detection is difficult. Now introduce a standard gage, gage detection more convenient, can be used for on-site testing. Standard test fixture shown in Figure 2. Gages should be produced in line with the requirements of the country 2, seized the training of equal parts must be. Detection method...