【摘 要】
：
The effect of solution temperature and cooling rate on microstructure and mechanical properties of laser solid forming (LSF) Ti-6Al-4V alloy is investigated. The samples are solutions treated at 900, 950, and 1000 C, followed by water quenching, air cooli
【机 构】
：
StateKeyLaboratoryofSolidificationProcessing,NorthwesternPolytechnicalUniversity,Xi'an710072,China
【出 处】
：
ChineseOpticsLetters
论文部分内容阅读
The effect of solution temperature and cooling rate on microstructure and mechanical properties of laser solid forming (LSF) Ti-6Al-4V alloy is investigated. The samples are solutions treated at 900, 950, and 1000 C, followed by water quenching, air cooling, and furnace cooling, respectively. It is found that the cooling rate of solution treatment has a more important effect on the microstructure in comparison with the solution temperature. The martensite \alpha’ formed during water quenching results in the higher hardness and tensile strength but lower ductility of samples. With decreasing the cooling rate and increasing the solution temperature, the width of primary \alpha laths increases, and the aspect ratio and volume fraction decrease, which make the hardness and tensile strength decrease and the ductility increase.
其他文献
在频域用角谱理论分析了矩形波导激光器谐振腔的耦合系数,计算了矩形波导中EH11模的耦合系数,本文的方法可以推广用于对其它模的分析。
The radiation reaction effects on electron dynamics in counter-propagating circularly polarized laser beams are investigated through the linearization theorem and the results are in great agreement with numeric solutions. For the first time, the propertie
历史较长、种类繁多的气体激光器，迄今已开发许多种产生短光脉冲的方法。但是与染料激光器等其它激光器相比，气体激光器的增益带窄，这对产生微微秒脉冲是不利的。
针对光刻物镜对镜片间隔调节精度高、范围大的需求，提出一种利用气体压差提供驱动力的压力双膜片轴向调节机构。并对该轴向调节机构的不同膜片宽度、厚度以及凸台宽度进行优化分析，在特定压力范围内得到调节机构的优化尺寸参数，分析调节机构在优化后的固有频率。同时分析在轴向调节过程中引入的镜片面形误差，得到镜片面形的Zernike系数。结果表明该压力双膜片轴向调节机构的镜片面形误差主要为power项和球差项，面形峰谷(PV)值优于13.45 nm，均方根(RMS)值优于2.851 nm，满足光刻物镜对调节机构镜片面形的要
采用10GHz基准时钟光和10Gbit/s的数据脉冲信号光注入到锁模激光二极管,降低了周期抖动,当注入功率为-5dBm,在基准时钟光波长等于锁模激光二极管的光波长时,获得的最小抖动为0.25ps,采用混合锁模激光二极管,在注入功率为 27dBm时,其Q值达3000。
针对太阳能利用技术中, 动态和准确模拟太阳光照的问题, 研制了一种基于轨道参数的全天候室内太阳模拟装置。根据静态的太阳轨迹数据, 实时进行装置灯光的模拟运行, 并在运行中, 实时检测灯照与太阳光的近似度。实验结果表明, 此模拟装置的氙灯光源光谱分布在经过失配误差处理后波长能够满足GBPT12637-90中A级要求, 模拟器的辐照度范围为0~1600W/m2 , 平均辐照度为1000W/m2, 照度范围为0~65000lux, 有效辐照面积为400cm2 , 动态模拟偏差为4.3%。此装置基本实现了太阳光照