【摘 要】
：
A new operation policy-quasi-batch distillation for recovering infinitesimal amounts species existing in a mixture is presented. In quasi-batch distillation ope
【机 构】
：
State Key Laboratory of Chemical Engineering
论文部分内容阅读
A new operation policy-quasi-batch distillation for recovering infinitesimal amounts species existing in a mixture is presented. In quasi-batch distillation operation, feed is introduced with a constant flow rate onto the feed stage of the column, and the flow rate of the distillate is the same as that of the feed, whereas the bottom product is withdrawn periodically. The behavior of quasi-batch distillation is simulated and analyzed through an example on heavy water separation. Comparing with continuous or batch distillation, the new operation policy is more reliable and efficient to achieve higher recovery of dilute component. This is especially suitable for separating small amount of precious species from large amount of raw material.
其他文献
Antimony-doped tin oxide(ATO) nanoparticles were prepared by the mild hydrothermal method at 200 ℃ using sodium stannate, antimony oxide, sodium hydroxide and
The study on arsenopyrite and realgar of bacterial oxidation shows that the chemical behaviors of different arsenic-bearing sulphides oxidated by thermophilic b
The solidified microstructure of immiscible alloys strongly depends on the nucleation, diffusional growth, especially the coalescence of the second phase drople
Copper single crystal specimens with the longitudinal axis parallel to the [013] double-slip-orientation were grown through Bridgman technique. The fatigue test
A nickekdiimine catalyst [N, N-bis(2,6-diisopropylphenyl)-1,4-diaza-2,3-dimethyl-1, 3-butadiene nickel dibromide, DMN] was supported on palygorskite clay for et
Poly (phthalazinone ether sulfone) (PPES) with 1:1 and 1:3 ratios of bisphenol A (BPA) unit to phthalazinone unit were selected as samples. Polymer precipitatio
The density of molten Ni-W alloys was measured with a modified pycnometric method. It is found that the density of the molten Ni- W alloys decreases with temper
Continuous SiC(OAl) fibers, named KD-A fibers, were prepared by the melt-spinning of ceramic precursor polyaluminocarbosilane, air-curing, and pyrolizing at 1 3
A comprehensive experimental and numerical study of solder joints for plastic leaded chip carrier (PLCC) 84-Pin,1.27 mm pitch was carried out. The reliability o
A new bimetallic complex containing Zn and La was prepared from a salen ligand possessing methoxyl groups at the 3, 3-positions. The structural feature is that