Self-propagating reaction mechanism of Mg-TiO2 system in preparation process of titanium powder by m

来源 :稀有金属(英文版) | 被引量 : 0次 | 上传用户:wanghao521146
下载到本地 , 更方便阅读
声明 : 本文档内容版权归属内容提供方 , 如果您对本文有版权争议 , 可与客服联系进行内容授权或下架
论文部分内容阅读
The novel method for the preparation of titanium powder by multi-stage reduction was proposed.The primary reduction adopted self-propagating high-temperature syn-thesis(SHS)mode.This paper focuses on the primary reduction process of Mg-TiO2 system under the condition of off-balance reaction.The effects of different material ratios,material arrangement methods and reaction initiation modes on the SHS reaction process of Mg-TiO2 system and its reaction mechanism were systematically studied.SHS mode was used to Mg-TiO2 system,and non-stoichiometric low-valent titanium oxide intermediate including α-Ti(Ti2O type)and TiO was directly obtained(with oxygen content of 13.93 wt%).SHS reaction initiated by local ignition is more sufficient than by overall heating method.Compared with the loose setting materials,the compacts can increase the effective contact interface of the reactants,and SHS reaction proceeds more sufficiently,which is favorable for obtaining lower oxygen content product.The adiabatic temperatures of the Mg-TiO2 system at different initial conditions were calculated according to the improved calculation method.When the initial temperature is 298 K,the adiabatic tem-perature of Mg-TiO2 system is between 1363 and 2067 K at different material ratios.Therefore,unreacted or partially excess Mg at the reaction front will diffuse into the unre-acted region in gas or liquid form,thereby preheating the material and initiating further SHS reaction.
其他文献
以重庆武隆区的一处滑坡为研究对象,结合该滑坡的分布特征及水文地质条件,利用传递系数法对其进行稳定性计算,评价分析不同水位时,各种工况下的滑坡体稳定性,根据计算结果并结合滑坡的具体特征,提出合理的防治措施建议.
硅噻菌胺是一种三甲基硅基取代的噻吩甲酰胺类活性化合物,为高效的小麦全蚀病杀菌剂药物.依据起始原料的不同,重点介绍了以2-丁酮和氰基乙酸乙酯、3-氯-2-丁酮和丙炔酸甲酯、3-巯基-2-丁酮和3-甲氧基丙烯酸甲酯、三甲基硅基乙炔、N-烯丙基-3-(三甲基硅基)丙炔酰胺为原料的五种合成路线,对比分析了每种合成工艺的优劣势及硅噻菌胺制备过程中的杂质以及减少杂质的应对方法.
A solid-phase extraction resin SIRs-P227/XAD-7HP was prepared by impregnating extractant P227 onto macroporous resin XAD-7HP beads.SIRs-P227/XAD-7HP beads were characterized by Fourier transform infrared spectroscopy(FTIR)and scanning electron microscopy(
以乙烯基硅油等为基料,添加低密度导热陶瓷粉体制得导热垫片.探讨了不同类型的导热陶瓷粉体的复配方式及用量、乙烯基硅油的黏度、表面处理剂的用量及导热粉体的加料顺序对导热垫片性能的影响.结果表明,采用氮化硼/球型硅微粉复配制得的导热垫片的综合性能优于氮化硼/氢氧化铝复配制得的导热垫片;采用黏度为500 mPa·s的乙烯基硅油即可满足客户对导热垫片力学性能的要求;当表面处理剂添加量为0.8 g时,可以保证粉体在垫片内均匀分散;制备胶料时,需要先添加球型硅微粉,依靠硅微粉增加体系黏度,搅拌一定时间后再添加氮化硼,此
根据克拉玛依市2018年各水资源利用指标进行水资源承载力评价,评价结果为严重超载,超载成因主要为克白地区地下水超采严重,农业用水和生活用水量超指标.结合现状水资源利用结构提出一系列调控措施以缓解水资源承载力超载现状.
In this communication,the electrical conduc-tivities and thermal expansion studies of microwave sin-tered co-doped ceria Ce0.8Y0.2-xDyxO2-δ(x=0,0.05,0.10,0.15 and 0.20)solid electrolyte materials for inter-mediate temperature solid oxide fuel cells(IT-SOF
通过对黏土料进行不同击实功能及不同单位面积冲量标准击实试验得到最大干密度、最优含水率,并分析他们之间的关系,验证现场黏土料填筑含水率与最优含水率之间的关系是否满足设计技术指标要求,以便更好地指导现场黏土填筑施工,确保施工质量满足相关技术规范的要求,为现场质量管控提供依据.
绩溪抽水蓄能电站钢岔管HD值4048m·m,其规模居国内前列.为检验钢岔管制作及焊接施工质量,验证结构的可靠性,部分消除钢岔管的尖端应力并使尖状缺陷钝化,保证钢岔管安全运行,进行了原型水压试验.试验结果表明,原型观测结果与有限元数值模拟计算成果基本吻合.
To explore the silicate lattice-based nanophos-phors,a series of Eu3+-doped Z2Si3O8(Z = Mg,Ca and Sr)materials were prepared by sol-gel procedure.The metal nitrates and silica powder were used as precursor components for the synthesis of these luminescent
对景洪水电站水力式升船机上闸首,以基岩水平峰值加速度0.35g作为设计地震,按规范给出的标准设计反应谱生成的人工地震波作为地震动输入,并分别在此基础上放大1.2和1.4倍,建立三维有限元模型采用时程法进行动力分析,并采用非线性损伤本构模型来考虑坝体损伤区域的应力释放和混凝土在承载后出现的软化效应,分析了升船机上闸首在上下游正常蓄水位时坝体的地震响应.根据混凝土损伤区域判断升船机上闸首整体抗震能力,以出现贯通性损伤区确定上闸首抗震极限.