【摘 要】
：
The effect of deep cryogenic treatment on the mechanical properties of 80CrMol2 5 tool steel was investigated.Moreover,the effects of stabilization (holding at
【机 构】
：
Department of Materials Engineering
论文部分内容阅读
The effect of deep cryogenic treatment on the mechanical properties of 80CrMol2 5 tool steel was investigated.Moreover,the effects of stabilization (holding at room temperature for some periods before deep cryogenic treatment) and tempering before deep cryogenic treatment were studied.The results show that deep cryogenic treatment can eliminate the retained austenite,making a better carbide distribution and a higher carbide amount.As a result,a remarkable improvement in wear resistance of cryogenically treated specimens is observed.Moreover,the ultimate tensile strength increases,and the toughness of the sample decreases.It is also found that both stabilization and tempering before deep cryogenic treatment decrease the wear resistance,hardness,and carbides homogeneity compared to the deep cryogenically treated samples.It is concluded that deep cryogenic treatment should be performed without any delay on samples after quenching to reach the highest wear resistance and hardness.
其他文献
The electrochemical migration (ECM) behavior of the electrically conductive adhesives (ECAs) filled with pure Ag powder or Ag-plated Cu composite powder with va
The delayed-state-derivative feedback (DSDF) is introduced into the existing consensus protocol to simultaneously improve the robustness to communication delay
Submicron diamonds were co-deposited on aluminum substrates with copper from the acid copper sulfate electrolyte by electrolyte-suspension co-deposition.After s
New ultra-lightweight sludge-red mud ceramics (ULS-RMC) were prepared by red mud (RM),clay and dried sewage sludge (DSS).The properties and mechanism of RM in t
A fluidized bed jet milling process was used to make micro-fine high Nb-containing TiAl alloyed powders from the chippings obtained by crushing the Ti-45Al-8.5N
To determine mirror surface finishing conditions and efficient and economical superfinishing conditions for pure titanium and titanium alloys,an abrasive film i
BaZr1-xScxO3-0.5x (x=0.07,0.10,0.13,0.16) powders were prepared by solid-state reaction method,and ZnO was used as sintering aid.Samples with different amount o
A new constant false alarm rate (CFAR) target detector for synthetic aperture radar (SAR) images is developed.For each pixel under test,both the local probabili
The observing failure and feedback instability might happen when the partial sensors of a satellite attitude control system (SACS) go wrong.A fault diagnosis an
A novel quantitative structure-property relationship (QSPR) model for estimating the solution surface tension of 92 organic compounds at 20 ℃ was developed bas