笔者看了13期的《用多功能卡巧修主板打印端口》一文后,也想对该文做一补充。多功能卡虽然可以解决问题,但这种卡市面上很少见,而且不支持高速打印,设置也很繁琐(须以跳线开关关闭软驱接口、硬盘接口、以及串口来避免与主板相应端口造成冲突,同理主板上的打印口也要在BIOS中关闭才能正常设置和使用多功能 After reading the 13th issue of “Printing a Port with a Multifunctional Card,” I also wanted to make a supplement to this article. Although the multi-function card can solve the problem, but this card is rare in the market, and does not support high-speed printing, the setting is also very cumbersome (jumper switch to be shut down floppy disk interface, hard disk interface, and serial port to avoid the corresponding port on the motherboard caused Conflict, the same reason the printer port on the motherboard should also be closed in the BIOS to set and use the normal multi-function