【摘 要】
：
Thermal spraying of cermet coatings is widely used for protection of machining parts against wear and corrosion. These coatings consist of WC particles in metal
【机 构】
：
Materials and Technology Institute,Central Metallurgical Research and Development Institute
论文部分内容阅读
Thermal spraying of cermet coatings is widely used for protection of machining parts against wear and corrosion. These coatings consist of WC particles in metal binders such as Co, Cr and Ni. Three kinds of WC powders with different metal binders (Co, NiCr and CoCr) were sprayed by low power plasma spray system on Al-Si-Cu alloy substrate. Fundamental aspects of sprayed cermet coatings, including (i) the effects of binder type on the coating structure, (ii) the hardness and (iii) the microstructure, were investigated. All cermet coatings have the same phase structure such as WC and W2 C. However, the intensities of these phases are different in each coating, mainly due to the difference in solidification rate in each case. Moreover, the hardness measurements are found to be different in each coating. The results show that, binder type has a significant effect on the physical and mechanical properties of the sprayed coatings.
其他文献
The multilayer gradient CrN/ZrN coatings were synthesized by a dual cathode DC magnetron sputtering.The influence of different species of reaction gases and par
Through eliminating voids not affecting the primary bonding process, and incorporating interlayer and flexible base material, the interface geometry character a
Fe-Al/WC intermetallic composite coatings were prepared by high velocity arc spraying (HVAS) technology on 20G steel and the oxidation performance of Fe-Al/WC c
SiCp/Sialon ceramic manix composites were fabricated by pressureless sintering method using the Sialon powder synthesized from the kaolin clay and submicron SiC
The effect of addition of A1 on crystal structure microtexture and magnetostrictioncoefficient in Tb0.3Dy0.7Fe1.95 alloy were studied.The results show that addi
Modified sensing membranes based on fluorescence quenching were prepared by the sol-gel meth-od, using formamide as the drying control chemical additive, tetrae
Nanoparticle reinforced nickel matrix composite coatings, such as n-Al2O3/Ni, n-SiO2/Ni, n-SiC/Ni and n-TiO2/Ni, were fabricated by brush plating technique. Har
Using Mo, B-Fe alloy and Fe powders as raw materials, and adding C, Cr and Ni ingredients, respectively, or C, Cr and Ni mixed powders, ternary boride hard allo
Based on IEC standards and Chinese national standards of sintered NdFeB materials, in the paper the hightemperature, room-temperature properties and thermal sta
The nanotopography of the surface of silicon wafers has become an important issue in ULSI device manufacturing since it affects the post-chemical mechanical pol