论文部分内容阅读
传真机发送电平通常设置0～15dB,若设置不正确,则会影响通信。设置方法笔者归纳有两大类:一类是软件法;一类是硬件法。下面分别作一简述。软件法则是以编程的方法确定,通常有两种方法:一种方法是通过设置7#软开关的5～8位进行调整,7#软开关的5～8位四位二进制数,可在-1～-16dB的范围内调整发送电平,具体操作是按FUNC+*+#+START/COPY键,直到显示器上显示SW07=
Facsimile transmission level is usually set 0 ~ 15dB, if set incorrectly, it will affect the communication. I set the method summarized in two categories: one is the software method; one is the hardware method. The following were a brief description. Software rules are programmed to determine the method, there are usually two ways: One method is to set the soft switch # 7 to adjust the 7 # 7 soft switch 5-8 four-digit binary number can be - Adjust the sending level within the range of 1 ~ -16dB, press FUNC + * + # + START / COPY key until the display shows SW07 =