钒钛磁铁矿金属化球团固结机理研究

来源 :烧结球团 | 被引量 : 0次 | 上传用户:gwj19861113
下载到本地 , 更方便阅读
声明 : 本文档内容版权归属内容提供方 , 如果您对本文有版权争议 , 可与客服联系进行内容授权或下架
论文部分内容阅读
以转底炉工艺为基础,在实验室模拟条件下,研究了钒钛磁铁矿金属化球团的固结机理。讨论了配碳量(C/O)、还原温度、还原时间对球团金属化率和抗压强度的影响,确定了金属化球团的固结机理。研究发现:钒钛磁铁矿金属化球团的抗压强度主要与金属铁相的数量和形态以及金属化球团内孔隙的大小有关;金属化球团孔隙的大小主要取决于配碳量高低和脉石所形成的渣相对金属化球团内部孔隙的填充状态;金属铁相的数量和形态则取决于金属化球团的还原程度。随着还原温度升高和还原时间延长,金属化球团内部金属铁相密集度增加,渣相流动性改善,从而导致金属化球团孔隙减少且变小,球团强度增加。 Based on the rotary hearth furnace process, the consolidation mechanism of the metallized pellets of vanadium-titanium magnetite was studied under laboratory simulation conditions. The effect of C / O, reduction temperature and reduction time on the metallization rate and compressive strength of pellets was discussed. The consolidation mechanism of metallized pellets was discussed. The results show that the compressive strength of vanadium-titanium magnetite metal pellets is mainly related to the number and morphology of metal iron phases and the size of pores in the metalized pellets. The size of the metalized pellet pores mainly depends on the carbon content And gangue formed slag relative to the filling of the pores inside the metalized pellet; the amount and morphology of the metal iron phase depends on the degree of reduction of the metalized pellets. With the increase of reduction temperature and the reduction time, the concentration of metallic iron phase in the metallized pellets increases, and the fluidity of the slag phase improves. As a result, the porosity of the pellet decreases and becomes smaller and the pellet strength increases.
其他文献
目的:观察与研究在右胸小切口心脏不停跳情况下的心脏直视手术(常温体外循环)与在正中切口心脏停跳下的心脏直视手术(低温体外循环)对心肌损害程度.方法:将30例单纯房间隔缺
目的 探讨肾上腺髓质素(adrenomedullin,ADM)基因微卫星多态性(CA重复序列)与动脉粥样硬化性脑梗死(atherosclerotic cerebral infarction,ACI)的关系.方法 应用PCR,检测189
目的评价 CT 测量食管裂孔宽度的临床意义并认识食管裂孔疝(EHH)在多层螺旋CT(MSCT)上的表现。方法(1)在140例成人的胸、腹部正常 MSCT 图像上,测量了代表食管裂孔宽度的膈肌
目的 探讨内皮素受体拮抗剂是否对CCl4引起的大鼠肝纤维化有阻滞作用.方法 实验中采用的是通过CCl4损伤引起的肝硬化门脉高压大鼠模型,随机分为正常对照组、肝硬化模型组、PD
提出了一种基于类-属性关系依赖度的数据离散化方法,其特点是:借助统计学的λ相关系数,有效地捕获类-属性间的相互依赖,以此来选取最佳断点,并利用粗糙集属性依赖度分析方法,
应用标准CMOS工艺,同时结合体硅微机械加工技术,研制成功横向多晶硅p+p-n+微测辐射热计单元;基于研制成功的微测辐射热计,设计了规模为128×128面阵的非致冷红外焦平面.采用
成都铁路局针对到达重车数量逐年攀升的局面,采取以调度指挥为龙头,提升卸车组织精细化水平;以装卸机械化为手段,提升装卸作业效率;以健全机制为保障,提升卸车管理效能,促进卸
外网等值模型必须跟踪外网运行方式的变化以确保地调EMS应用软件的计算精度。为提高地区电网EMS应用软件的实用性,作者开发了自适应的外网等值自动生成系统。该系统利用IEC61
文章通过数值模拟分析了在工作面上、下隅角采用的封堵措施,以及在防治采空区漏风方面所起到的重要作用。针对大佛寺煤矿高瓦斯、易自燃、漏风大的特点,结合40104工作面的实
对46个皮革试样浸取液中Cr(Ⅲ)和Cr(Ⅵ)含量的测试进行了研究,结果表明:不同皮革试样浸取液中的Cr含量大小不一,且有的还相差较大.用双空白法测定有色皮革试样浸取液中的Cr(