论文部分内容阅读
中国设备管理协会,委托中国工程机械维修研究会主办,于1983年11月8日至10日在北京召开了全国刷镀技术应用推广会。当前我国对刷镀技术的应用推广工作很重视,这主要是因为刷镀技术在设备、器具零件维修中有着独特的重要作用,并有着明显的高生产率、高经济效益等优点。刷镀技术与常见的有槽电镀,从本质上看是相同的。但与槽镀相比,单位面积上电流密度大几倍到几十倍(通常300～400安培/分米~2),金属离子浓度高10～20倍,沉积速度快5～10倍,还有无槽的特点。它是一项在工件表面局部快速电化学沉积金属的新工艺、新技术。在修复工件公称尺寸,改变表面性质上,收到了实用的效果。金属表面镀层在1或0.5毫米以下,常用电压为8～14伏,镀笔46
China Association of Equipment Management, commissioned by China Construction Machinery Maintenance Research Association, held in November 8, 1983 to 10 in Beijing held a brush plating technology promotion. At present, our country attaches great importance to the promotion of the application of brush plating technology, mainly because the brush plating technology has a unique and important role in the maintenance of equipment and appliance parts, and has the obvious advantages of high productivity and high economic benefits. Brush plating technology and the common slot plating, essentially the same. But compared with the slot plating, the current density per unit area of several times to several times (usually 300 to 400 amperes / dm ~ 2), 10 ~ 20 times higher metal ion concentration, the deposition rate of 5 to 10 times faster, but also With or without groove characteristics. It is a new technology, new technology for local rapid electrochemical deposition of metal on the workpiece surface. In the repair of the nominal size of the workpiece, change the surface properties, received a practical effect. Metal surface coating at 1 or 0.5 mm below the common voltage of 8 to 14 volts, Pen 46