制备条件对稀土复合氧化物粉体材料性能的影响

来源 :中国稀土学报 | 被引量 : 0次 | 上传用户:wwling_girl
下载到本地 , 更方便阅读
声明 : 本文档内容版权归属内容提供方 , 如果您对本文有版权争议 , 可与客服联系进行内容授权或下架
论文部分内容阅读
用柠檬酸络合法制备出双掺杂CeO2基粉体材料,考察了柠檬酸用量、焙烧温度、升温速率和成胶温度等制备条件对粉体材料BET比表面积、孔容、平均孔径和平均粒径的影响。柠檬酸用量和焙烧温度对粉体材料的这些性能影响较大,升温速率只是对平均粒径产生影响,成胶温度对BET比表面积没有影响,对孔容和平均孔径影响也很小,对平均粒径影响大一些。通过对不同柠檬酸用量和不同焙烧温度所得样品进行XRD表征,发现双掺杂并未改变CeO2晶型,但晶胞参数略有增大,表明掺杂离子进入CeO2晶格。柠檬酸用量几乎不影响平均晶粒大小,而焙烧温度对平均晶粒产生较大影响,焙烧温度越高,平均晶粒越大。不同掺杂元素对粉体材料的表面性能也产生一定影响,掺杂Ca2+的平均粒径比同主族的Mg2+和Sr2+小。通过对不同制备条件的考察,为制备固体氧化物电解质粉体材料提供了基础。 The doping CeO2-based powder was prepared by citric acid complexation method. The effects of preparation conditions such as the amount of citric acid, calcination temperature, heating rate and temperature on the BET surface area, pore volume, average pore size and average Effect of particle size. The amount of citric acid and calcination temperature have great influence on these properties of the powder material, the heating rate only affects the average particle size, the gelation temperature has no effect on the BET specific surface area, and has little effect on the pore volume and the average pore size. Particle size greater impact. By XRD characterization of samples with different amounts of citric acid and different calcination temperature, it was found that double doping did not change the crystalline form of CeO2, but the unit cell parameters increased slightly, indicating that doping ions enter the CeO2 lattice. The amount of citric acid almost does not affect the average grain size, while the calcination temperature has a greater impact on the average grain size. The higher the calcination temperature, the larger the average grain size. Different doping elements also have certain influence on the surface properties of the powder materials. The average particle size of doped Ca2 + is smaller than that of Mg2 + and Sr2 + of the main group. Through the investigation of different preparation conditions, the preparation of solid oxide electrolyte powder materials provided the basis.
其他文献
采用共沉淀法制备了不同摩尔比(x=0, 0.1, 0.2~0.9, 1.0)的CexTi1-xO2复合氧化物, 考察了CuO/CexTi1-xO2对NO+CO反应的活性, 并用BET, TPR和XRD等技术对各试样进行了表征.结果
利用光学显微镜、图像分析仪和电子探针对低氧低硫的10PCuRE耐候钢板坯进行了观察和检测,采用干-湿周浸室内加速试验方法测得了试验钢的腐蚀率.用电化学方法测得了带锈样的阳
研究了稀土元素及其添加量对高碳铬铸钢力学性能和耐磨性的影响。结果表明:稀土能改善高碳铬铸钢中碳化物的形态分布,提高其综合性能,尤其稀土与热处理共同作用时,效果更显著。当