【摘 要】
：
The influence of quench transfer time on the microstructure and mechanical properties of 7055 aluminum alloy with and without zirconium was investigated by tens
【机 构】
：
Educational Key Laboratory of Non-ferrous Metal Materials Science and Engineering,School of Material
【基金项目】
：
国家重点基础研究发展计划(973计划);国家自然科学基金
论文部分内容阅读
The influence of quench transfer time on the microstructure and mechanical properties of 7055 aluminum alloy with and without zirconium was investigated by tensile properties test, optical microscopy, scanning electron microscopy and transmission electron microscopy. For the Zr-free alloy, the strength increases to the highest value at 20 s with transfer time, and then decreases slightly. The elongation decreases slowly with transfer time within 20 s, and more rapidly after 20 s. For the Zr-containing alloy, prolonging transfer time within 20 s results in slight decrease in the strength and elongation, and rapid drop of which is observed after 20 s. For the Zr-free alloy, prolonging transfer time can increase the percentage of intergranular fracture, which is mainly caused by wide grain boundary precipitate free zone. The failure mode of the Zr-eontaining alloy is modified from the predominant transgranular void growth and intergranular fracture to transgranular shear and intergranular fracture with increase in the transfer time, which is attributed to the wider grain boundary precipitate free zone and coarse equilibrium η phases in the matrix.
其他文献
Ce0.5Zr0.5O2 solid solution was successfully synthesized using cerium nitrate,zirconium nitrate,and urea as raw materials by the microwave irradiation method an
The magnetoelasfic performance of aligned polycrystalline Tt0.3Dy0.7Fe2 was investigated.It has been round that the strata-stress curve is nearly linear withou
The flow field formed when an aluminum ribbon is produced by twin-belt rapid solidification is simulated with the solu- tion algorithm (SOLA)-volume of fluid (V
The SnO2-polyaniline(SnO2-PAn) composite was prepared by microemulsion polymerization method using aniline, ammonium peroxodisulfate and SnO2 as starting materi
For vehicle integrated navigation systems, real-time estimating states of the dead reckoning (DR) unit is much more difficult than that of the other measuring s
On the basis of the microscopic phase-field dynamic model and the microelasticity theory, the characteristics of the coarsening behavior of γ phase in Ni-AI al
In view of the problem that the current single-antenna GPS attitude determination system can only determine the body attitude when the sideslip angle is zero an
The effects of polyurethane sponge pretreatment and slurry compositions on the slurry loading in precursor were discussed, and the,performances of stainless ste
The effect of heat treatment on the microsructure evolution of a high Nb containing TiAl alloy has been studied.The results indicate thatβ-segregation,α-segre
Based on the phase equilibrium calculation of the Ti-Al-N ternary system,the interfacial reactions and the phase formation sequences between different types of