我厂在生产Z435、ZL50轮式装载机产品时,设计制造了一套车削球面的靠模装置,用以加工锥齿轮球面和斜面。经生产使用证明,效果良好。一、结构与原理结构如图1所示,靠模用两个圆锥销定位并由两个螺栓拧紧安装在底板上,底板固定在C616车床的拖板上,拆下小刀架的丝杆,将固定轴的一端装入此孔内,用螺母、垫圈拧紧。固定轴的另一端装有仿形座 I plant in the production of Z435, ZL50 wheel loader products, the design and manufacture of a set of turning spherical by the device to bevel gear spherical and bevel processing. Proved by the use of production, the effect is good. First, the structure and principle of the structure shown in Figure 1, by the mold with two conical pin positioned by the two bolts tighten the installation on the floor, the floor fixed on the carriage of the C616 lathe, remove the knife holder screw, will One end of the fixed shaft into the hole, with a nut, washer tightened. The other end of the fixed shaft fitted with a profile seat