Discussion on Wave Transmission Coefficient Formulae of Submerged Breakwaters

来源 :中国海洋工程(英文版) | 被引量 : 0次 | 上传用户:qingqing008800
下载到本地 , 更方便阅读
声明 : 本文档内容版权归属内容提供方 , 如果您对本文有版权争议 , 可与客服联系进行内容授权或下架
论文部分内容阅读
Fifteen formulae of wave transmission coefficient for submerged breakwaters obtained during last 3 decades are presented, compared, and analyzed in this paper. The dimensionless parameters mainly involved in this discussion are the relative submerged depth R_c/h, relative wave height R_c/H_I, relative rubble size B/D_(50), relative breakwater width B/(H_I L_0~(1/2)) and wave breaker index ξ. It indicates that there exist notable differences among the computed results, which mainly originate from the limited experimental conditions and different analytical methods, even though the major tendency keeps similar. It is necessary to conduct more systematic studies to obtain better understanding about the mechanism of wave transmission over submerged breakwaters.
其他文献
The deformation and damage behaviors of strain hardening cementitious composites(SHCC) under the uniaxial stress state were investigated in this paper.Two ducti
桥梁的桥面防水、伸缩缝防水及主体结构防水能够提高桥梁的耐久性并大大延长桥梁的使用寿命。本文讨论了桥梁防水技术和质量控制要点。
The recent research and development of forged magnesium road wheel were reviewed. Methods of flow-forming, spin forging of manufacturing a forged magnesium allo
With Zn(NO_3)_2·6H_2O and NaOH as starting materials, a novel nest-like ZnO nanostructure was successfully synthesized by a solvo-thermal method. The products
The potential-pH diagrams of the Cr-H2O system at temperatures of 298, 323, 373 and 423 K were established through thermodynamic calculation with coupling of ex
Presented in this paper is a mathematical model to calculate the probability of the sediment incipient motion, in which the effects of the fluctuating pressure
Mg-9Al-xPr (x=0.4, 0.8 and 1.2, mass fraction, %) magnesium alloys were prepared by high-pressure die-casting technique. The effects of Pr on the microstructure
To deal with the moving boundary hydrodynamic problems of the tidal flats in shallow water flow models, a new wetting and drying (WD) method is proposed. In the