Corrosion behavior of AA2037 T8 Al alloy in a1 M Na OH aqueous solution was investigated using slow positron beam, together with microscopy techniques and electrochemical tests. The alloy was homogenized at 510℃ for 2 h and 30 s, respectively, before final peak aging, so that one Sample A had more dispersoids than Sample B after homogenization. It was found that S parameter of the Doppler-broadened annihilation was significantly decreased near the surface in both samples in the alkaline solution. With increasing the dissolution time,Sample A showed a slower decrease rate than Sample B,which might imply that the preexistence of more dispersoids might hinder the corrosion process in Sample A.Scanning electron microscopy and atomic force microscopy observations found that the surfaces of both samples were uniformly thinned due to intense chemical dissolution by the attack of OH-. With increasing the dissolution time,Sample B was corroded more substantially and produced more and larger pits in a short dissolution time than Sample A. Furthermore, polarization curves showed that Sample A had a lower corrosion current and corrosion rate than Sample B, which revealed that the presence of the dispersoids was responsible for the better corrosion resistance in the alloy. Corrosion behavior of AA2037 T8 Al alloy in a 1 M Na OH aqueous solution was investigated using slow positron beam, together with microscopy techniques and electrochemical tests. The alloy was homogenized at 510 ° C for 2 h and 30 s, respectively, before final peak aging, so that one Sample A had more dispersoids than Sample B after homogenization. It was found that S parameter of the Doppler-broadened annihilation was decreased decreased near the surface in both samples in the alkaline solution. With increasing the dissolution time, Sample A showed a slower decrease rate than Sample B, which might imply that the preexistence of more dispersoids might hinder the corrosion process in Sample A. Scanning electron microscopy and atomic force microscopy observations found that the surfaces of both samples were uniformly thinned due to intense chemical dissolution by the With increasing the dissolution time, Sample B was corroded more substantially and produced more and greater p its in a short dissolution time than Sample A. Further, polarization curves showed that Sample A had a lower corrosion current and corrosion rate than Sample B, which revealed that the presence of the dispersoids was responsible for the better corrosion resistance in the alloy.