Development of an Intelligent Vehicle Experiment System

来源 :中国机械工程学报 | 被引量 : 0次 | 上传用户:pengtao0615
下载到本地 , 更方便阅读
声明 : 本文档内容版权归属内容提供方 , 如果您对本文有版权争议 , 可与客服联系进行内容授权或下架
论文部分内容阅读
Existing vehicle experiment systems tend to focus on the research of vehicle dynamics by conducting performance tests on every system or some parts of the vehicle so as to improve the entire performance of the vehicle. Virtual technology is widely utilized in various vehicle test-beds. These test-beds are mainly used to simulate the driving training, conduct the research on drivers behaviors, or give virtual demonstrations of the transportation environment. However, the study on the active safety of the running vehicle in the virtual environment is still insufficient. A virtual scene including roads and vehicles is developed by using the software Creator and Vega, and radars and cameras are also simulated in the scene. Based on dSPACEs rapid prototyping simulation and its single board DS1103, a simulation model including vehicle control signals is set up in MATLAB?Simulink, the model is then built into C code, and the system defined file(SDF) is downloaded to the DS1103 board through the experiment debug software ControlDesk and is kept running. Programming is made by mixing Visual C?? 6.0, MATLAB API and Vega API. Control signals are read out by invoking library function MLIB/MTRACE of dSPACE. All the input, output, and system state values are acquired by arithmetic and are dynamically associated with the running status of the virtual vehicle. An intelligent vehicle experiment system is thus developed by virtue of program and integration. The system has not only the demonstration function, such as general driving, cruise control, active avoiding collision, but also the function of virtual experiment. Parameters of the system can be set according to needs, and the virtual test results can be analyzed and studied and used for the comparison with the existing models. The system reflects the running of the intelligent vehicle in the virtual traffic environment, at the same time, the system is a new attempt performed on the intelligent vehicle travel research and provides also a new research method for the development of intelligent vehicles.
其他文献
To study the influence of slenderness on the axial compressive performance of autoclaved fly ash solid brick masonry columns,compression experiments were conduc
Distribution and abundance of Pseudeuphausia sinica off the Changjiang River Estuary (30°00′-32°00′N,122°00′-123°30′E),the East China Sea were studied i
The glass fiber reinforced polymer (GFRP) tube is an effective material that can increase the bearing capacity and ductility of concrete.To study the mechanical
运用多目标决策分析原理 ,建立了线路方案灰色优选模型 ,编制了该模型的应用软件并给出了两个应用实例 By using the principle of multi-objective decision-making analys
A new kind of DP steel with about 40% martensite in matrix was developed from cold rolled Q345steel by continuous annealing simulation.Microstructure and mechani
Current highway tunnel lighting control systems are often manually controlled,resulting in significant energy waste.This article designs a fuzzy control algorit
A multi-domain collaborative simulation (MDCS) system for dual clutch transmission (DCT) was presented based on controller area network (CAN) bus.An interface c
A set of compressed natural gas (CNG) multi-point direct injection system of spark-ignited engines and the corresponding measurement and data acquisition system
To conform the design requirements of automotive ignition coils,a multi-input muhi-output(MIMO)model is proposed to estimate the technological parameters,such a
Most current Global System for Mobile Communications (GSM) frequency planning methods evaluate the interference and assign frequencies based on measurement repo