鍛模型腔的抛光,是鍛模制造的最后一道工序。过去我们采用风动砂轮机手工抛光,效率低,而且损耗大量的砂轮、毡轮及橡胶砂轮等,劳动环境恶劣,是鍛模制造的一项落后工艺。因此,对于这项工艺,我厂鍛模车间广大革命工人和革命技术人员,早就下定决心,革它的命,彻底解决这个“老、大、难”问题,改善劳动环境,摆脱繁重的体力劳动,提高生产效率,为鍛模生产闯出一条新路。但是由于过去厂内走资派推行叛徒、内奸、工贼刘少奇反革命修 Forging the mold cavity polishing is the last step forging die manufacturing. In the past we used the hand-polished pneumatic grinder, low efficiency, and the loss of a large number of grinding wheel, felt wheel and rubber grinding wheel, poor working environment, forging a backward manufacturing process. Therefore, for this process, the vast majority of revolutionary workers and revolutionary technicians in the die-casting workshop of our factory have long been determined to revolutionize their lives and completely solve this “old, big and difficult” problem, improve the working environment and get rid of the heavy Manual labor, improve production efficiency, break a new road for forging die production. However, due to the fact that in the past the capitalists practiced as a traitor and traitor, the traitor Liu Shaoqi built a counter-revolutionary