论文部分内容阅读
In meandering rivers,the flow pattern is highly complex,with specific characteristics at bends that are not observed along straight paths.A numerical model can be effectively used to predict such flow fields.Since river bends are not uniform-some are divergent and others convergent-in this study,after the SSIIM 3-D model was calibrated using the result of measurements along a uniform 180° bend with a width of 0.6 m,a similar but convergent 180° bend,0.6 m to 0.45 m wide,was simulated using the SSIIM 3-D numerical model.Flow characteristics of the convergent 180° bend,including lengthwise and vertical velocity profiles,primary and secondary flows,lengthwise and widthwise slopes of the water surface,and the helical flow strength,were compared with those of the uniform 180° bend.The verification results of the model show that the numerical model can effectively simulate the flow field in the uniform bend.In addition,this research indicates that,in a convergent channel,the maximum velocity path at a plane near the water surface crosses the channel's centerline at about a 30° to 40° cross-section,while in the uniform bend,this occurs at about the 50° cross-section.The varying range of the water surface elevation is wider in the convergent channel than in the uniform one,and the strength of the helical flow is generally greater in the uniform channel than in the convergent one.Also,unlike the uniform bend,the convergent bend exhibits no rotational cell against the main direction of secondary flow rotation at the 135° cross-section.