论文部分内容阅读
一、锻压机制动器摩擦片修复方法的改进六十年代初我厂引进了一台捷克LKM1600A型热模锻压力机,滑块行程次数每分钟80次。该机采用摩擦片制动器与摩擦片气动离合器机械联锁控制。摩擦片采用胶木石棉铜板,用铆接方法固定。由于机器工作时离合频繁,散热条件差,工作温度较高,使用一段时间后,引起摩擦片的破碎、脱落,造成锻压机的停车修理。用通常的方法调换摩擦片,工作寿命只有3～4个月,
First, the improvement of forging brake friction plate repair method Sixties early I plant the introduction of a Czech LKM1600A hot forging press, the number of slide trips 80 times per minute. This machine uses friction plate brake and friction plate pneumatic clutch mechanical interlock control. Friction plate made of bakelite asbestos copper, with riveting method fixed. As the machine clutch clutch frequently, poor cooling conditions, the working temperature is higher, after a period of time, causing the friction plate broken, off, causing forging machine parking repair. Replace the friction plate with the usual method, the working life of only 3 to 4 months,