【摘 要】
：
In functionally graded materials (FGM), the problem of interface stability caused by the volume deformation is commonly regarded as the key factor for its perfo
【机 构】
：
Key Laboratory for Silicate Materials Science and Engineering of (Ministry of Education),Wuhan Munic
【出 处】
：
武汉理工大学学报（材料科学版）（英文版）
论文部分内容阅读
In functionally graded materials (FGM), the problem of interface stability caused by the volume deformation is commonly regarded as the key factor for its performance. Based on test results, in terms of finite element method (FEM) this paper analyzed problems in the shrinkage of functionally graded material interface of shield concrete segment, which was designed and produced by the principle of functionally graded materials. In the analysis model, the total shrinkage of concrete was converted into the thermal shrinkage by means of the method of "Equivalent Temperature Difference". Consequently, the shrinkage stress of interface layer was calculated and compared with the bond strength of interface layer.The results indicated that the volume deformation of two-phase materials of functionally graded concrete (FGC) segment, which were the concrete cover and the concrete structure layer, showed better compatibility and the tension stress of interface layer, which was resulted from the shrinkage of concrete and calculated by ANSYS, was less than the bond strength of interface layer. Therefore, the interface stability of functionally graded concrete segment was good and the sliding deformation of interface layer would not generate.
其他文献
The three-dimensional stress distributions in the area surrounding indentation pattern for three different materials,Al2O3,Si3N4 and SiC were analyzed by finite
The characteristics of novel Nd-Fe(Ni, Co, Al)-B microstructure prepared by strip casting technique were studied. The novel microstructure was observed using sc
The mechanism of expansion of mortars and pastes with limestone filler due to external sulfate attack was studied.Mortars and pastes made at water to solid rati
A new no-reference blocking artifact metric for B-DCT compression video is presented in this paper. We first present a new definition of blocking artifact and a
A new all-zero block determination rule was used to reduce the complexity of the AVS-M encoder. It reuses the sum of absolute difference of 4×4 block obtained
YbAl3(BO3)4 crystal of good optical quality was grown by the flux method. The structure of YbAl3(BO3)4 crystal was determined by single-crystal X-ray diffractio
Based on analysis of three alloys with various Re contents, the effects of Re on the interfacial structure characteristic and interfacial dislocations of γ/γ
Two comparative models taking into account of momentum,energy and mass transport coupled with chemical reaction kinetics were proposed to simulate gas transport
Zinc aluminosilicnte glasses containing Li2 O, ZnO , Al2 O3 and SiO2 were prepared by conventional melting and quenching technique, and subsequently converted t
Age hardening characteristic and tensile property of Mg-3.5Dy-4.0Gd-3.1Nd-0.4Zr alloy were investigated. The alloy exhibits a considerable age hardening effect