为确定钢板弹簧各片的长度,目前各汽车厂设计部门所采用的方法,实际上是文献(1)所介绍的方法。钢板弹簧各片长度的选择是为保证各片沿长度作等应力分布。然而,等应力分布对于钢板弹簧的主片来说是不够合适的。因此,在计算完各片长度之后,为减少主片的负荷,还必须对各片长度加以修正。这里所介绍的确定钢板弹簧叶片长度的方法是按苏联汽车研究院关于汽车钢板弹簧设计 In order to determine the length of each piece of leaf spring, the current design method used by automobile factory is actually the method introduced in literature (1). The choice of the length of the leaf spring sheet is to ensure that the pieces along the length for equal stress distribution. However, the equal stress distribution is not suitable for the main leaf of the leaf spring. Therefore, after calculating the length of each piece, in order to reduce the load on the main piece, the length of each piece must also be corrected. Described here to determine the length of the leaf spring blade method is based on the Soviet Automobile Institute on the automotive leaf spring design