【摘 要】
：
The effects of the flame temperature and the absorption coefficient on interactions between radiative heat transfer and the flame behavior were numerically inve
【机 构】
：
Department of Aerospace System Engineering, Sejong University, Seoul 05006, Republic of Korea
论文部分内容阅读
The effects of the flame temperature and the absorption coefficient on interactions between radiative heat transfer and the flame behavior were numerically investigated using high-fidelity numerical code with the discrete ordinates method.To study the effects of the flame temperature and the absorption coefficient,three different flame temperatures and four different absorption coefficient conditions were selected,so twelve test cases were studied in total.In the numerical test results,radiation effects resulted in preheating of the reactant gases and heat loss from the product gases.A higher flame temperature resulted in stronger preheating effects in reactants near the flame.Due to the preheating effects,with the appropriate absorption coefficient,the peak temperature appeared at the flame front.Lower flame temperatures resulted in larger reabsorption effects in the product zone.The peak temperature at the flame front and the flame speed were influenced by the combined effects of preheating and radiative heat loss at the flame front.Depending on the conditions,due to those effects,the peak temperature and the flame speed could increase or decrease.When the absorption coefficient was Sufficiently large,the temperature decrease was reduced in the product zone.
其他文献
In this study,mixed convection heat transfer and fluid flow is numerically investigated in an open system enclosure containing a heated obstacle.Effects of the
In this paper,the visualization of the thermo-hydrodynamic behavior in flat-plate pulsating heat pipe(FP-PHP)with HFE-347 is experimentally investigated.The FP-PHP is vertically placed with filling rate of 20%to 70%and heating power of 20 W to 140 W.A hig
The tip leakage flow in different axial gaps is numerically investigated based on the Reynolds-Averaged Navier-Stokes equations and k-ω SST turbulent model usi
In modern high-load high-pressure turbine,the secondary flow in the blade channel is very strong and occupies a large spanwise region.Although high-quality experimental data at the stage interfaces have been obtained in previous research,the influence of
The non-linear temperature glide in the supercritical CO2 cooling process makes the heat transfer pinch point of heat exchanger show multiplicity,like size,loca
The stationary lumped-cell model was developed and used to simulate the thermal characteristics of domestic biomass boiler with helically coiled tube heat excha
In order to determine the sensitivity of influencing factors on NOx emission in gas-fired heating and hot water eombi-boilers,the orthogonal method was adopted
Cooling tower is crucial equipment in the cool-end system of power plant and the natural draft counter-flow wet cooling tower (NDWCT) gets wide application.The
Molten salt and supercritical carbon dioxide (S-CO2) are important high temperature heat transfer media,but molten salt/S-CO2 heat exchanger has been seldom rep
Fine bubbles have been widely applied in many fields such as industry,medical engineering and agricultures.Therefore,many attentions have been paid to the study