Formation mechanism of calcium hexaluminate

来源 :International Journal of Minerals Metallurgy and Materials | 被引量 : 0次 | 上传用户:jay12
下载到本地 , 更方便阅读
声明 : 本文档内容版权归属内容提供方 , 如果您对本文有版权争议 , 可与客服联系进行内容授权或下架
论文部分内容阅读
To investigate the formation mechanism of calcium hexaluminate(CaAl_(12)O_(19), CA_6), the analytically pure alumina and calcia used as raw materials were mixed in CaO/Al_2O_3 ratio of 12.57:137.43 by mass. The raw materials were ball-milled and shaped into green specimens, and fired at 1300–1600°C. Then, the phase composition and microstructure evolution of the fired specimen were studied, and a first principle calculation was performed. The results show that in the reaction system of CaO and Al_2O_3, a small amount of CA_6 forms at 1300°C, and greater amounts are formed at 1400°C and higher temperatures. The reaction is as follows: CaO ·2Al_2O_3(CA_2) + 4Al_2O_3 → CA_6. The diffusions of Ca~(2+) in CA_2 towards Al_2O_3 and Al~(3+) in Al_2O_3 towards CA_2 change the structures in different degrees of difficulty. Compared with the difficulty of structural change and the corresponding lattice energy change, it is deduced that the main formation mechanism is the diffusion of Ca~(2+) in CA_2 towards Al_2O_3. To investigate the formation mechanism of calcium hexaluminate (CaAl_ (12) O_ (19), CA_6), the analyzed pure alumina and calcia used as raw materials were mixed in CaO / Al_2O_3 ratio of 12.57: 137.43 by mass. The raw materials were ball -milled and shaped into green specimens, and fired at 1300-1600 ° C. Then the phase composition and microstructure evolution of the fired specimen were studied, and first principle calculation was performed. The results show that in the reaction system of CaO and A1_2O_3, a small amount of CA_6 forms at 1300 ° C, and greater amounts are formed at 1400 ° C and higher temperatures. The reaction is as follows: CaO · 2Al_2O_3 (CA_2) + 4Al_2O_3 → CA_6. The diffusions of Ca ~ 2+) in CA_2 towards Al_2O_3 and Al ~ (3+) in Al_2O_3 toward CA_2 change the structures in different degrees of difficulty. Compared with the difficulty of structural change and the corresponding lattice energy change, it is deduced that the main formation mechanism is the diffusion of Ca ~ ( 2+) in CA_2 towards Al_2O_3.
其他文献
介绍TDD-TDM多路复用终端设备的原理、数据格式和电路框图.该设备适合于无线通信的场合.还着重介绍系统的构成、帧结构和有关电路的设计(以8路为例).
目的 探讨氯乙烯(VCM)致DNA损伤与DNA修复基因和代谢酶基因多态性的关系.方法 彗星试验检测DNA损伤,并按DNA损伤情况将接触VCM的研究对象分为DNA损伤组(75人),采用病例对照设计方法选择对照组(75人),用聚合酶链反应-限制性酶切片段多态性技术(PCR-RFLP)和PCR测XRCC1(Arg194Trp,Arg280His和Arg399Gln)、XPD(Ile199Met,Asp3
In the present study, multiwalled carbon nanotubes(MWCNTs), gold nanoparticles(AuN Ps), and glutathione(GSH) were used to fabricate multilayer nanoscale thin fi
随着中国电子行业的迅速发展,使用高压设备越来越多,随之而来的高压用电安全问题也引起了该领域专家的重视,有很长一段时间没有得到很好的解决.变频器的出现,可以使得机器设
该文从挂篮荷载计算、施工流程、支座及临时固结施工、挂篮安装及试验、合拢段施工、模板制作安装、钢筋安装、混凝土的浇筑及养生、测量监控等方面人手,介绍了S226海滨大桥
To elucidate the intrinsic reaction mechanism of cementitious materials composed of red mud and coal gangue(RGC), the hydration kinetics of these cementitious m
就SOLALUCE落地镗床工装目前存在的问题进行了分析,从工件的定位方式、夹紧力作用点的选择、夹紧力大小的确定等几方面提出了改进措施。 The existing problems of SOLALUCE
随着科学技术的快速发展和创新,我国电气工程在运用的过程中也开始运运用先进的技术,现如今,电气工程的自动化技术已被广泛运用在我国乃至世界各个行业中,并且取得了较为显著
在移动通信系统中 ,采用智能天线可以通过降低系统信噪比 (SIR)来提高容量。基于 CDMA蜂房小区系统的容量分析 ,讨论智能天线对系统容量的影响。 In mobile communication s