一、校准前的检查工作及调整方法1.检查测力活塞是否在活塞槽内若不在,将会影响力值,甚至将活塞压弯。调整方法是将摆杆稍微抬起,把活塞对准活塞槽,逐步放下摆杆,用手触摸到活塞完全在活塞槽内即可。2.检查摆杆刀子是否在刀程内若不在,活塞将运行不到位,影响力值。调整方法是将摆杆稍微抬起,把刀口对准刀程,缓慢放下摆杆,观测到刀口完全在刀槽内即可。 First, the calibration before the inspection and adjustment methods 1 Check the force measuring piston in the piston groove if not in, will affect the force value, and even the piston bending. Adjustment method is to lift the pendulum slightly, the piston aligned piston groove, and gradually put down the pendulum, touch the piston completely in the piston groove can be. 2. Check whether the pendulum knife in the tool path if not, the piston will not run in place, the impact of value. Adjustment method is to lift the pendulum slightly, the knife-edge alignment knife, slowly put down the pendulum, observed blade edge can be completely in the knife slot.