【摘 要】
：
The effects of RE (rare earth) oxide on viscosity of mold fluxes were investigated with a rotary viscometer. The results show that: (1) The viscosity of mold fl
【机 构】
：
College of Materials and Metallurgy,College of Materials of Science and Engineering
论文部分内容阅读
The effects of RE (rare earth) oxide on viscosity of mold fluxes were investigated with a rotary viscometer. The results show that: (1) The viscosity of mold fluxes is remarkably increased by RE oxide addition, especially when the mass fraction of RE oxide is more than 10%. (2) By addition of RE oxide, precipitation of the insoluble particles with high melting point from the molten slag with the decreasing of the temperature leads to the increase of viscosity. Viscosity curve shows that RE oxide is soluble in some extent in mold fluxes. When RE oxide is in a state of supersaturation, the existence of insoluble particles also makes the viscosity of mold fluxes increase. (3) Not only the viscosity of mold fluxes can be reduced, but also the capacity to dissolve and absorb RE oxide can be increased by Li2O, B2O3 and BaO. However, the contents of Li2O, B2O3, and BaO should be controlled to suitable levels. (4) The solidification temperature of mold fluxes can be increased by the addition of RE oxide, which is unfavorable to heat transfer and lubrication of mold fluxes between steel shell and mold.
其他文献
We present a Monte Carlo (MC) method to simulate the scattering for medium within randomly distributed particles,discuss the convergence of this method by varyi
目的 评价和分析2009-2013年全国抗结核药物敏感性试验(简称“药敏试验”)熟练度测试结果,改善我国结核病实验室药敏试验能力.方法 2009-2013年对全国有能力开展药敏试验的省
Curvatures are important geometric attributes of surfaces. There are many applications that require as a first step the accurate estimation of curvatures at arb
Hyaluronan may be used in tissue engineering as a scaffold, and since the scaffold should degrade after the cells have proliiferated, and heat treatment is a me
An optimal concentration of the etching solution for deep etching of silicon, including 3% tetramethyl ammonium hydroxide and 0.3% (NH4)2S2O8, was achieved in t
Alumina dispersion strengthened copper(ADSC) alloy was produced by internal oxidation.The hardness,ultimate tensile strength and electrical conductivity measure
A rapidly solidified Al85Y4Nd4Fe7 (%, in nominal atomic fraction) alloy was prepared by melt spinning. As-quenched and as-annealed microstructures were studied
By introducing the homogenous coordinates, degree elevation formulas and combinatorial identities, also by using multiplication of Bernstein polynomials and ide
The spraying-dried HA (ASD) was employed. ASD was plasma-sprayed onto ice to obtain hollow HA microspheres. The particle size of the sample was determined with
The influence of mold pressing parameters on the positive temperature coefficient of high-density polyethylene/carbon black composites was investigated. The com