223型汽化器上浮子室的底部凸出部分,由于加浓按钮经常使用,使浮子下端的三角针在浮子室壳下端的凸出部分——即三角针底座磨损过大,有些甚至磨穿。这样在起动主发动机时,打开小油箱油阀,马上就会从该处漏油,因此汽油浪费很大。由于汽化器总成是铝制品,不能用锡和铜来焊补,我们用一种简易方法修补浮子室漏孔,经使用效果良好。现介绍如下: 1.卸下汽化器总成,拆开浮子室,拿出浮子,并清洗之。 The bulge of the bottom of the 223 carburetor upper float chamber is often used due to the enrichment button so that the triangular needle at the lower end of the float is worn excessively at the lower part of the lower part of the float chamber housing, This starts the main engine, open the small tank valve, will immediately leak oil from the Department, so a lot of waste of gasoline. As the carburetor assembly is made of aluminum, tin and copper can not be used to weld, we use a simple method to repair leaks in the float chamber, the use of good results. Are introduced as follows: 1. Remove the carburetor assembly, open the float chamber, take out the float, and clean it.