Simulation and Optimization of unwanted Gas Heating for HVAC

来源 :2017中国汽车工程学会汽车空气动力学分会学术年会 | 被引量 : 0次 | 上传用户:en2113
下载到本地 , 更方便阅读
声明 : 本文档内容版权归属内容提供方 , 如果您对本文有版权争议 , 可与客服联系进行内容授权或下架
论文部分内容阅读
  Whole vehicle thermal management model was built up to simulate the flow field and temperature field Figure 1: Schematic of cross-section mesh of engine compartment and external field,especially the area around HVACs inlet.Flow field was studied and optimization was made to reduce the temperature of HVACs inlet.Test results agree well with simulation results with maximum disagreement of 2℃.
其他文献
  Brake discs are brake system components that inhibit vehicle motion by converting kinetic energy to thermal energy via friction with brake pads during the p
  The paper mainly introduces the trajectories of asymmetric leaf spring in the condition of the vehicle,and elaborates the using of the center expanding mapp
  This paper takes an engine optimization design for the vibration velocity and light weight as the target.First the crankcase is optimized to control vibrati
  The oil temperature of the commercial vehicle hydraulic power steering system is related to the bore diameter of power steering gear and parameters of power
  The torsion beam for a certain model of motor vehicle cracked in the bench test.The analysis of cracked torsion beam through fracture microscopic analysis,m
  The purpose of this paper is to investigatethe impacts of different under-cover structures on temperature fluctuations of heat sensitive parts,and to predic
  In order to solve the problems of little actuator output force,low efficiency and slow response speed,a linear motor sus-pension actuator with high precisio
  In this paper,a model of engine,vehicle dynamic,cooling system,engine block,lubrication system and underhood has been established,furthermore,based on energ
  Tire blowout will cause serious safety problems and impair the vehicle stability.Many studies in the literature proposed the stability controller for the ti
针对某款车型近期市场上出现发电机不发电和机械风扇扇叶折断问题,提出增加下护板方案.文中对发动机下护板进行了三大轮多种方案的CFD分析论证,然后,通过在各种恶劣工况下的